Nothing is more frustrating for a homeowner than a faulty furnace. However, if your furnace breaks down, you’ll need to fix it immediately. There are a few things to watch out for to spot problems early and avoid paying for a heating repair in Santa Maria, CA.
Troubleshooting Tips For Furnaces
- Check The Thermostat
If you use a smart or programmed thermostat, you must take extra precautions as the temperature changes. Verify that the thermostat is set to the heating or automated modes. To turn on the heating system, raise the temperature.
Your thermostat should be on heat mode at a high temperature while you wait a few minutes for the heating system to start working. If not, move on to the subsequent stages for heating repair in Santa Maria, CA, troubleshooting.
- Verify The Power Supply
Make that your appliance’s switch is still in the on position. No matter if you have gas or electricity, an electrical switch must always be in the on position for it to function. If you have an electric appliance, you should check the circuit breaker to ensure the heating system receives energy.
Make sure the gas heater you possess has an indicator light. Additionally, make sure your gas heater has adequate fuel to operate. Examine the gas control valve to ensure it is in the on position. Contact a specialist as well.
- Clean Filters
Unclean filters might be one of the most common causes of inoperative heating systems. The airflow is hindered if the filters are very unclean, necessitating heating service. Verify the cleanliness of the air filters, as well as the registers and vents. Additionally, ensure no rugs or furniture obstructs any registers or vents.
- Check Condensation Pan
Check your system’s condensation pan. If it’s full, take the pan out. Next, check for obstacles in the condensation drain pipe. Many devices will turn off automatically if the condensation pan is full. You should be able to restart the heating system after emptying the pan and clearing off any moisture using the system reset.
- Reset The Overloaded Motor
Your entire system will shut down if the heater’s motor reaches an unsafe temperature (typically due to dirt and other debris). To guarantee that the heating unit will cool, it is advised to turn it off and give it 30 minutes to rest.
After, attempt to turn on the heater again. If the motor doesn’t start working, test the procedure for a second time. If, after the third attempt, it’s not successful, you must consult an expert for heating repair in Santa Maria, CA.
Reach Out To An Expert Repair And Maintenance Company
You have tried everything possible to ensure your heater is functioning correctly and there are still some issues with the system. If this is the case, it’s a good idea to schedule an appointment with Organ & Sons Mechanical Inc for furnace repairs. Be sure your home is safe from costly furnace repairs by scheduling an appointment for a tune-up today!
